34321 Data Path Control DPC: SCSI driver error, invalid initiator Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 This error indicates the SCSI driver encountered an "impossible" situation while communicating over the SCSI bus. This is likely due to a problem with the SCSI hardware (i.e. cables, workstation card, MCE or DNE, etc). The SCSI hardware should be checked as outlined in the Service Manual Troubleshooting Guide. If the problem persists after all hardware causes have been ruled out, the firmware programmer responsible should be notified. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. SCSI hardware (i.e. cables, workstation card, MCE or DNE, etc) 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:03 2008 PST